Auto CodesAuto Codes Blog

Is the check engine light on in your Hyundai car Dashboard?

Is the check engine light on in your Hyundai Elantra, Accent, Sonata, Kona, Tosan, or Santa Fe? If you are seeing the check engine light first time on your dashboard can be scary.

Check engine light can turn on for many serious reasons and need repair immediately. Autocodes.co can help you identify the issue and take the following steps to address it. Here are some of the things that can cause the check engine light to turn on:

  • A misfire in the engine
  • A problem with the fuel system
  • A problem with the emissions system
  • A problem with the sensors
  • A problem with the transmission
  • A problem with the electrical system

We have listed the most common reasons for this warning.

Related Article: P1273 Nissan diagnostic trouble code

 Why Check the Engine Light on in Hyundai

Gas Cap:

Your cap is not tight, damaged, or broken. This can lower fuel pressure and let fuel vapors escape, decreasing fuel efficiency and reducing harmful emissions.

Catalytic Converter:

Catalytic Converter:faulty

These substances can build up in the catalytic converter and block the flow of exhaust gases, which can lead to some problems:

  • Reduced engine power
  • Increased fuel consumption
  • Engine misfires
  • Failure to pass emissions tests

Faulty Spark Plugs or Spark Plug Wires or ignition Coils:

faulty plug and ignation coil

Over time, you will need new spark plug coils or wires. Spark plugs create a spark that starts your engine. Spark plugs generate a spark to initiate your engine. If the plugs do not spark enough, your engine might misfire, reducing fuel efficiency and performance, or it may not start.

Oxygen Sensor:

Faulty  Oxygen Sensor

If your oxygen sensor is exposed to hot exhaust gas for a long time, it may need to be replaced. The oxygen sensor gives the car’s computer important information about the air and fuel mixture. If the oxygen sensor is not working properly, the computer may give the engine too much or too little fuel. If the engine gets too little fuel, it could stop working completely. A faulty oxygen sensor causes the car to use too much fuel. It will produce a lot of smoke and smell bad.

Faulty Camshaft:

Faulty  Faulty Camshaft

A camshaft is a critical component of your car’s engine. It is responsible for opening and closing the engine’s valves, allowing the engine to breathe and run properly. If the camshaft is faulty, it can cause problems with your car’s engine.

A faulty Crankshaft:

A faulty Crankshaft:

This serious problem can cause many issues with your car’s engine. If the crankshaft is defective, it can cause the engine to misfire, run rough, or even stall and the Check engine light can indicate in your car dashboard. The crankshaft is a critical component of the engine, and it is responsible for converting the up-and-down motion of the pistons into rotational motion.

Speed Sensor Faulty:

Speed Sensor Faulty

A speed sensor is a device that measures the rotational speed of a shaft or wheel and sends the signal to the computer. If the vehicle speed sensor stops working, this may affect the following component.

  • Anti-lock braking system (ABS)
  • Electronic stability control (ESC)
  • Transmission control system (TCS)
  • Odometer

Related Posts

1 of 2

2 Comments

Leave A Reply

Please Login to Comment.